The daily cleaning of the steam room massage bathtub can be carried out with general liquid detergent and soft cloth. Acetone and ammonia or products based on these substances are prohibited. (Disinfectants containing formic acid or ketone are prohibited)
If you accidentally scratch the bathtub, and the scratch does not penetrate the surface, use dry or wet 1500# water scrubbing paper to lightly polish to smoothness (the place where the sandpaper is polished must be kept moist), and then use a 10# mirror glaze called Meguiar If the luster cannot be restored, the surface chemicals can be polished, and then a layer of polishing wax paste can be applied.
The scale on the surface can be cleaned with a light acid detergent. It is recommended to wipe it with a cloth with lemon in a warm state.
After many years of use, if you want to keep the surface bright, you can polish it with a polishing agent to make it shiny as new.
Thoroughly clean the acrylic surface after each cleaning, and do not let the detergent enter the circulation system.
Try to avoid direct spraying with water on the lamp tube and computer panel in the product.
In the steam room, the scale in the steam engine should be cleaned regularly, and the weak acid solution should be put into the steam engine to heat it to volatilize the acid. Shut down to remove the accumulated water in the machine, and then rinse with water.
When the water hardness is too high, it is recommended to clean the hydromassage device every two years. The specific method is as follows:
1. Fill the bathtub with hot water (40 degrees).
2. Add liquid detergent at a dosage of 2g per liter of water, and start the hydromassage device to run for 5 minutes.
3. Stop the water pump and drain the water.
4. Fill the bathtub with cold water and start the hydromassage device to run for 3 minutes.
5. Stop the water pump, drain water and clean the massage tub.
After the product is used, cut off the power as much as possible to extend the service life. Maintenance must be performed after disconnecting the power supply. A licensed electrician must check the leakage switch condition every six months to ensure leakage safety protection and the switch works normally.