1. Make an inspection
Put the bathtub in a relatively spacious place and check whether its surface is intact. All kinds of spare parts should be readily available, and each nozzle should be brightly fastened. The quality of the motor is closely related to the use effect of the outdoor massage bathtub, so it is necessary to pay special attention to its installation, piping and quality.
2. Pay attention to waterproof
Before going to the designated location, waterproof the parts that are prone to water leakage with silica gel. Connect the parts that can be connected first, so as not to be inconvenient for installation after being placed in the designated position. The waterproofing of the parts must be done well, especially the connection between the drain and the water pipe of the motor is very critical.
3. Fixed position
Place the outdoor jacuzzi in a designated location. If you are in a bathroom with a small space, avoid excessive tilting or bumping of the tank. Put the drain pipe into the pipe and make sure that the water is unobstructed. After the cylinder body is placed, the anchor screws should be adjusted continuously, so that all the screws are safely on the ground to ensure that the overall level is maintained.
4. Secure connection
After connecting the plug, make waterproof around the electrical connection board to avoid leakage accidents. After the inspection, there is no abnormal situation, and the hot and cold water pipes can be connected in place. Before connecting the water pipe, do a power-on test of the motor to check whether the sound meets the requirements. If not, rework immediately.
5. Detection function
After making the connection, put the outdoor jacuzzi completely, and adjust the level again. Turn on the water and electricity, check all the functions, and solve the problem in time. The surfing effect of the bathtub should be inspected mainly. The strength of flushing, the sound of the motor, and the presence or absence of foreign objects are the main contents of the inspection.
6. Protect the finished product
Drain the water in the tank and wipe clean the remaining water droplets at the bottom of the tank and the spray hole to prevent the bathtub from rusting at the spray hole due to long periods of inactivity. When installing the bathtub, other decorations in some homes have not been completed. At this time, the installer must use a film to protect the bathtub from damage.